Leaderboard

Thanks both, much appreciated. @Dad3353 - I discovered Ohmmage when look at hifi... I'm not the most technical of people and it still blows my mind a bit, but that's helpful to know! I do plan, though, to stick to just the one speaker to keep the noise down - if I ever have a house where I can go louder, I'll be looking at a "proper" amp. Mind you, it's impressive what you can get in a pedal form factor these days. Once they get past an inherently conservative generation of guitar players, I wouldn't be wholly surprised to see fewer and fewer bands using traditional maps on stage (save rich ones with roadies and a 'look' to maintain, of course...).

I concur with the advice above : one speaker cable with a 1/4 mono jack at each end is all that's required. It can be plugged into either of the cab sockets; these are doubled up to give the option of linking to a second cab, if desired. This is called 'daisy-chaining'. Probably moot in your case, but one should be aware that the total impedance of cabs connected in this way must not be below the minimum impedance of the amp. Two 8Ohm cabs connected in this 'daisy-chain' fashion would present a 4Ohm load to the amp. If the amp supports this, all well and good. If not, expect costly 'magic smoke'. The 'Baby Bomb' pedal amp, for instance, will not support two such cabs (the output socket is labelled : 8-16 Ohms...), but your single cab should be fine. Ignore, then, the second cab socket. Hope this helps.

IIRC the two jack sockets are for if you are hooking up another cab (I could be way off base here and I’m more than happy to be corrected by those who know better/for sure). However, just plug the micro amp into either socket, you’ll be fine.